Knowledgebase
Moving the Coordinator to a new machine
Posted by - NA - on 04 May 2014 08:01 AM

Below you will find a recommended procedure for moving the Coordinator to a new machine.


Please perform the following steps:
------------------------------------

1. Still with your current Coordinator online, install the new machine with IncrediBuild Coordinator.
2. On the old (current) coordinator machine, please right click on the IncrediBuild tray icon -> Coordinator Monitor.
3. Mark all Agents  -> right click ->Set Registry Value
4. Make sure that the "Value Category" is set to: BuildService
5. Under the "Name" please write: CoordHost
6. Under the "Data" please write: <the new Coordinator machine name>
7. On the old (current) machine, open Coordinator Monitor -> View -> Settings -> License -> General
8. Press on the "Unload License"
9. Go to the new Coordinator machine, open Coordinator Monitor -> View -> Settings -> License -> General
10. Press on the "Load License File..."
11. If you are using backup Coordinator there is a need to reinstall it and configure it to use the new main Coordinator machine. Please refer to: Using a backup Coordinator chapter.

  • Please note that this procedure is valid for IncrediBuild v4.5 and above. For older versions, please contact IncrediBuild support.

 

(2462 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk Software by Kayako xoreax.helpserve.com